MV Agusta Brutale 675 Workshop Manual page 70

- using the specific tool, unhook the 2 springs (1);
The substitution of the springs must be car-
ried out utilising the appropriate tool.
B
Before reattaching the springs, ensure that
the stand can swing freely (with no friction
or sticking).
- remove the hinge plate (2);
- remove the nut (3) and free the stand from the plate
but pulling off the pin (4);
Proceed in the opposite order for reassembly, following
the instructions below:
- move the stand pin (4) in support, with grease on the
first threads;
- leave the stand free to move;
- tighten the nut (3);
- once again make sure the stand is free to move.
Stand nut tightening torque: 25 N·m
Maintenance
- 54 -
1
2
4
3
25 N•m