Panasonic KX-TVP100E Installation Manual And Instructions For Use page 175

4.5.5 System Parameter Settings
Value Range
Parameter
(default)
Outgoing Call Port No.
Ports (1, 2, 3, 4)
Message Port No.
Waiting Lamp (1, 2, 3, 4)
Ports
Message 1. Yes
Waiting Lamp 2. No
for Every
Message
Max. Digits for 1–48 digits
Callback No.
Callback No. 1–10 sec
Entry Interdigit
Time-Out
System Callback Up to 32
No.
Specifies the port numbers used for the Message
Waiting Notification-Device feature. The VPS
makes outgoing calls using a port specified in this
field. At least one port must be specified.
Specifies the port numbers used for the Message
Waiting Notification-Lamp feature.
The VPS turns on the message waiting lamp of
the extension using a port specified in this field.
At least one port must be specified.
If set to "Yes", the VPS will turn on the message
waiting lamp of the extension every time a new
(No)
message is recorded in the mailbox even if the
message waiting lamp has not been turned off
from a previous message.
If set to "No", the VPS will turn on the message
waiting lamp for only the first message. It will
not notify subsequent messages until the
Subscriber has accessed the VPS to receive the
message.
This setting is useful if the first attempt has
unsuccessful for some reason.
Specifies the maximum number of digits the
(20)
caller can enter as a callback number. This
number will be displayed on beepers if "Beeper
Callback No. Entry Mode" is activated.
Sets the maximum time allowed between each
(5)
digit on Beeper Callback No. Entry. If the caller
does not enter any digits within this length of
time following the last digit entry, the VPS
considers it as the end of entry and does not
accept additional entry.
Specifies a telephone number displayed on
digits
Subscriber's beepers as a callback number when
(None)
"Type" is set to "Beeper".
[Note]
If "Beeper Callback No. Entry Mode" is
activated, the callback number entered by the
caller will be displayed on the destination beeper
instead of this system callback number.
Description/Function
System Administrator
Reference
Number to
Dial
p.4-23
M.W.N.-
Lamp
p.3-41
Callback
Number
Entry
p.3-7
Number to
Dial
p.4-23
Type
p.4-24
Beeper
Callback No.
Entry Mode
p.4-33
4-67