Table of Contents
Advertisement
4.5.6 Hardware Settings
Value Range
Parameter
(default)
CPC Signal
1. None
2. 6.5 msec
3. 150 msec
4. 300 msec
5. 450 msec
6. 600 msec
Disconnect
1–8 sec
Time
Dial Mode
1. DTMF
2. Pulse 10 pps
3. Pulse 20 pps
(DTMF)
4.5.6.3 PBX Interface Parameters
Three types of parameters are used to program the VPS for optimal signaling and
performance with your PBX.
System Administration Top Menu → 1 → 6 → 3
Program – Hardware – PBX Interface Menu
4.5.6.3.1 Dialing Parameters
These parameters tell the VPS how to initiate and control call transfers, how to set
up outgoing calls and how to control message waiting lamps on extensions. The
easiest way to verify the correct code sequences for non-Panasonic KX-T series
telephone systems is to manually execute the sequences from a single line telephone
(SLT) with your PBX.
4-78
System Administrator
Specifies the minimum time required to detect a
break in the CPC (Calling Party Control) signal
from the PBX. The VPS detects that the line has
been disconnected when there is a break of the
CPC signal.
(6.5)
Specifies the amount of time that the line is
(2)
temporarily unavailable to access after a call has
ended.
Specifies dial mode for DTMF or Pulse.
If you specify Pulse, pulse speed (10/20 pps) must
be selected.
[NOTE]
You can not select "3. Pulse 20 pps".
1. Dialing Parameters
2. Inband Signaling
3. Digit Translation Table
SELECT ITEM AND PRESS RETURN–KEY
Description/Function
Reference
PBX Type
p.4-79
- Quick Links:
- Introduction
Hide quick links:
Advertisement
Chapters
Table of Contents
