Maintenance And Inspections - Canon imageRUNNER ADVANCE 8105 Getting Started

Maintenance and Inspections

•
When cleaning the machine, first turn OFF the main power switch, then disconnect the power cord . Failure
to observe these steps may result in a fire or electrical shock .
•
Disconnect the power cord from the power outlet regularly, and clean the area around the base of the
power plug's metal pins and the power outlet with a dry cloth to ensure that all dust and grime is removed .
If the power cord is connected for a long period of time in a damp, dusty, or smoky location, dust can build
up around the power plug and become damp . This may cause a short circuit and result in a fire .
•
Clean the machine using a slightly dampened cloth with a mild detergent mixed with water . Do not use
alcohol, benzene, paint thinner, or other flammable substances . Check detergent for flammability prior to
use . If flammable substances come into contact with a high-voltage area inside the machine, it may result
in a fire or electrical shock .
•
There are some areas inside the machine which are subject to high-voltages . When removing jammed
paper or when inspecting the inside of the machine, do not allow necklaces, bracelets, or other metal
objects to touch the inside of the machine, as this may result in burns or electrical shock .
•
Do not burn or throw used toner cartridges into open flames, as this may cause the toner remaining inside
the cartridges to ignite, resulting in burns or a fire .
•
Make sure that the power plug is firmly inserted into the power outlet after cleaning the machine . Do not
use the machine while the connection is loose, as doing so may cause a fire .
•
Check the power cord and power plug regularly . If the following conditions occur, contact your local
authorized Canon dealer, as the condition may cause a fire:
There are burn marks on the power plug .
-
- The blade on the power plug is deformed or broken .
The power goes OFF and ON when the power cord is bent .
-
- There are cuts, cracks, or indentations on the power cord .
A part of the power cord becomes hot .
-
•
Check the power cord and power plug regularly to make sure that they are not handled in the following
manner, as this may result in a fire or electrical shock:
The connection part of the power plug is loose .
-
- Stress is being applied to the power cord by a heavy object or by affixing it with staples .
The power plug is loose .
-
The power cord is tied in a bundle .
-
- The power cord protrudes into a walkway .
The power cord is in front of a heater .
-
xxix