Confirming Tcp/Ipv6 Settings - Canon imageRUNNER ADVANCE 8105 Getting Started

Confirming TCP/IPv6 Settings

The following is the procedure for confirming that the TCP/IPv6 network connections are properly set.
1
On the TCP/IP Settings screen, press [IPv6 Settings] → [PING Command] .
4
2
In [PING Command], check the following .
Pressing [Start] after entering an IPv6 address existing on the network in [IPv6 Address] displays the result of the PING command on the
touch panel display.
Pressing [Start] after entering the machine's host name in [Host Name] displays the result of the PING command on the touch panel
display.
If this result is inappropriate, check the settings described in "Interface Settings, " on p. 3-7, "TCP/IPv6 Settings, " on p. 4-9 and "Settings
Common to TCP/IPv4 and TCP/IPv6, " on p. 4-15.
•
If you set the startup time of the machine's network functions by following the procedure in "Startup Time Settings, " on p. 4-27, execute
the PING command only after the time set as the startup time passes.
•
If you connect the machine to a switching hub, the machine may not be able to connect to a network even though your network
settings are appropriate. This problem may be resolved by delaying the startup of network communications for the machine. See
"Startup Time Settings, " on p. 4-27 for information on how to set up the startup time.
3
On the TCP/IP Settings screen, press [SNTP Settings] → check the following .
After pressing [Check NTP Server], if <OK> is displayed, time synchronization is working correctly via SNTP.
If <Error> is displayed, check the settings for [NTP Server Address] set in step 3 of "Settings Common to TCP/IPv4 and TCP/IPv6, " on p. 4-15.
Even if you perform [Check NTP Server], time settings are not updated. Check that communications are possible between the machine and
the NTP server.
4-24
Protocol Settings