Settings Common to TCP/IPv4 and TCP/IPv6
This section describes the procedure for specifying the settings common to TCP/IPv4 and TCP/IPv6 using the control panel.
Specify the settings required for your network environment. If you want to use both TCP/IPv4 communications and TCP/IPv6
communications, specify the settings required for both protocols.
After performing this procedure, follow the procedure in "Confirming TCP/IPv4 Settings, " on p. 4-23 and "Confirming TCP/IPv6
Settings, " on p. 4-24 to check whether the network settings are correct.
1
On the TCP/IP Settings screen, press [LPD Print Settings] → specify the following .
[On]: You can use LPD as the print application.
•
You can only output a banner page if you are using the PCL Printer Kit or the PS Printer Kit.
•
Output of a banner page is set on a print-job basis. Even if [On] is selected for <LPD Banner Page>, a banner page cannot be output for
a print job unless it is set.
4
4-15
Protocol Settings