Canon imageRUNNER ADVANCE 8105 Getting Started page 156

2
Press [Network] → [TCP/IP Settings] → [Use HTTP] .
3
Press [On] .
8
[On]: HTTP server is used.
[Off ]: HTTP server is not used.
•
To use SSL, set [Use SSL] in [MEAP Settings] in [License/Other] in [Management Settings].
•
Settings for [Use SSL] are also applied to the settings for [Use SSL] in [Remote UI] in [Management Settings].
•
To set <Use SSL> to 'On' , it is necessary to set the key pair and server certificate necessary for performing Encrypted SSL communications
in [Certificate Settings] in [Management Settings] of the machine. For information on generating the key for SSL, see e-Manual >
Security.
4
Press [OK] .
The selected mode is set.
5
Press [Close] .
6
Turn the main power of the machine OFF, wait 10 seconds, and then turn the power ON .
The setting for [Use HTTP] and [Use SSL] is activated only after you restart the machine (the main power switch is turned OFF, and then
back ON). For instructions on turning the power ON/OFF, see Chapter 1, "Before You Start Using This Machine."
8-8
Before Starting SMS (Preparations)