Tcp/Ipv6 Settings - Canon imageRUNNER ADVANCE 8105 Getting Started

TCP/IPv6 Settings

This section describes the procedure for setting TCP/IPv6 using the control panel. After specifying the settings for TCP/IPv6, follow
the procedure in "Settings Common to TCP/IPv4 and TCP/IPv6, " on p. 4-15 to specify the required settings, and the procedure
in "Confirming TCP/IPv6 Settings, " on p. 4-24 to check whether the network settings are correct. If the settings for TCP/IPv4 are
already specified and you have finished specifying the settings common to TCP/IPv4 and TCP/IPv6, only check the network
settings after completing this procedure. If you want to use IPv4 communications at the same time, follow the procedure in "TCP/
IPv4 Settings, " on p. 4-3 to specify the required settings, and the procedure in "Confirming TCP/IPv4 Settings, " on p. 4-23 to check
the settings.
The machine can use up to seven of the following IPv6 addresses. With IPv6 communication, multiple IPv6 addresses can be used
at the same time.
If the IPv6 address assigned to the machine is the same as another node, you may not be able to perform IPv6 communication, even though an
IPv6 address is displayed on the screen.
■ Link local address (1)
An address that is only valid within the same link. A link local address is automatically set using a specific prefix (fe80::) and an interface
identifier generated from the MAC address of the machine. When the machine is using the functions of IPv6, one link local address is always
registered.
■ Manual address (0 or 1)
A fixed address that is set from the control panel.
Stateless address (0 to 4)
■
A stateless address is automatically set using the machine's MAC address and the prefix (information indicating the network belonged to)
included in the RA (Router Advertisement) notified by the router when the machine is started.
■ Stateful address (0 or 1)
A stateful address can be obtained from a DHCP server using DHCPv6.
1
On the TCP/IP Settings screen, press [IPv6 Settings] → [Use IPv6] .
4
4-9
Protocol Settings