Canon imageRUNNER ADVANCE 8105 Getting Started page 91

● Obtaining automatically an IP address:
☐
[DHCP], [RARP], or [BOOTP]: [On]
If this information cannot be obtained via DHCP, RARP, or BOOTP after you restart the machine, enter the IP address, subnet mask, and
gateway address to use the settings entered in this step.
•
If the machine is restarted after DHCP, RARP, or BOOTP settings are specified, the TCP/IP Settings screen displays the IP address setting
values obtained from the DHCP, RARP, or BOOTP server. (If the IP address, host name, and domain name have been previously set, these
will be overwritten by the setting values obtained from DHCP, RARP, or BOOTP.)
•
If you use DHCP without the DNS dynamic update function, it is recommended that an identical IP address be assigned to the machine
at all times. (If the IP address is not identical, the host name for the machine will not correspond to the IP address.)
4
On the TCP/IP Settings screen, press [DNS Settings] → [DNS Server Address Settings] .
5
In <IPv4>, specify the following .
If you want to use dynamic DNS updating, enter the IPv4 address of the DNS server in [Primary DNS Server].
If you do not want to set up a secondary DNS server, enter <0.0.0.0>.
If you set [BOOTP] or [DHCP] to 'On' in step 3, the IP address of a DNS server you set manually will be overwritten.
4
4-5
Protocol Settings