NEC EcoPowerGateway N8142-36F User Manual page 83

Peripheral Configuration
IMPORTANT:
requests or the base I/O addresses. If an assigned value is already used
by another resource, it appears in yellow. Any yellow value must be re-
assigned.
Option
Serial Port
Base I/O Address
Interrupt
USB 2.0 Controller
Serial ATA
SATA AHCI
Make sure to avoid any conflict in the interrupt
Parameter Description
Disabled Specify whether serial port is enabled
or disabled.
[Enabled]
[3F8h] Specify the base I/O address for serial
port.
2F8h
3E8h
2E8h
IRQ 3 Specify the interrupt request (IRQ) for
serial port.
[IRQ 4]
Disabled Specify whether the USB 2.0 controller
is enabled or disabled.
[Enabled]
Disabled Specify whether the onboard SATA
controller is enabled or disabled. Do
[Enabled]
not change this item to "Disabled" in
normal operation.
The AHCI (Advanced Host Controller
[Disabled]
Interface) is always disabled on this
Enabled
system. This option is view only.
This menu appears only when [Serial
ATA] is enabled.
Configuring Your EcoPowerGateway 4-13
Your Setting
[ ]: Factory-set