Relocating/Storing The Ecopowergateway - NEC EcoPowerGateway N8142-36F User Manual

RELOCATING/STORING THE EcoPowerGateway

Follow the procedure below to relocate or store the EcoPowerGateway:
IMPORTANT:
If the EcoPowerGateway needs to be relocated/stored due to a
change in the floor layout to a great extent, contact your service
representative.
Store the EcoPowerGateway under the storage condition
(temperature: –10 to 55°C, humidity: 20 to 80%, without
condensation) to allow internal devices and the EcoPowerGateway
to operate correctly in the next operation.
Observe the following instructions to use the EcoPowerGateway safely.
Failure to follow these instructions may result in death or serious personal
injury. See pages 1-4 to 1-16 for details.
Do not disassemble, repair, or alter the EcoPowerGateway.
■
Disconnect the power plug before working with the EcoPowerGateway.
■
Observe the following instructions to use the equipment safely. Failure to
follow these instructions may cause a fire, personal injury, or property
damage. See pages 1-4 to 1-16 for details.
Make sure to complete component installation.
■
Pay attention not to drop the device.
■
Do not leave the device being pulled out from the rack.
■
Do not install the device with its cover being removed.
■
Do not pinch your finger with mechanical component.
■
Avoid installation in extreme temperature conditions.
■
Do not pull out a device from the rack if the rack is unstable.
■
Do not leave more than one device being pulled out from the rack.
■
WARNING
CAUTION
Maintenance 5-5