Rear View - NEC EcoPowerGateway N8142-36F User Manual

2-4 General Description

Rear View

1-4
1 Slot for power supply unit
Install the power supply unit that supplies DC power to the Module Enclosure.
The last digit indicates installation order. Slots 1 and 2 contain factory-installed power units.
Slots 3 and 4 are equipped with blank covers. Install the separately priced N8181-76F power
units into these slots to make the maximum configuration with four power supply units.
2 DC output lamp
Lights green when DC output is turned on. Goes off when DC output is turned off. The last
digit indicates the corresponding DC output port.
3 DC output switch
Press this switch to turn on or off the DC output. The last digit indicates the corresponding DC
output port.
4 DC output port
Supplies DC power to the target device. Connect the dedicated cable to this port. The last
digit indicates the port number.
5 Management port
Connector that accepts 100BASE-TX/10BASE-T interface.
1-3 1-2
2-4
4-4
1-1
2-3 2-2
3-4 3-3
4-3 4-2
9
2-1 7
3-1
3-2 6
8 5
4-1