NEC EcoPowerGateway N8142-36F User Manual page 118

6-12 Troubleshooting
When STATUS lamp is lighting in amber:
On-screen
message
Proc Temp Alm 02
Proc Temp Alm 09
BB Temp2 Alm 02
BB Temp2 Alm 09
BB Temp1 Alm 02
BB Temp1 Alm 09
VBAT Alm 02
VBAT Alm 09
Description
A low temperature alarm
is detected in processor.
A high temperature alarm
is detected in processor.
A low temperature alarm
is detected in base board.
A high temperature alarm
is detected in base board.
A low temperature alarm
is detected in base board.
A high temperature alarm
is detected in base board.
A voltage alarm (lower
limit) occurred on lithium
battery.
A voltage alarm (upper
limit) occurred on lithium
battery.
Action
1. Check if dust or stain is adhered to the fan of
the power unit or not.
2. Check if blank cover is surely installed in the
slot which does not contain any power unit.
3. Check the ambient temperature of
installation location.
4. Take one of the following measures to reboot
(reset) the maintenance card.
* Press Ctrl + Alt + Del.
* Issue a command from Web browser of
EXPRESSSCOPE Engine 2 or NEC
ESMPRO Manager.
5. Take one of the following measures to power
off the maintenance card and then on.
* Press the Maintenance switch to power off
the maintenance card, then press it again
to power on.
* Issue a command from Web browser of
EXPRESSSCOPE Engine 2 or NEC
ESMPRO Manager.
6. Power off the maintenance card by pressing
the Maintenance switch.
Press the POWER switch of
EcoPowerGateway to turn off the power,
then turn it on. Then, press the Maintenance
switch to turn on the maintenance card.
7. If the same error persists, contact your
service representative.
1. Take one of the following measures to power
off the maintenance card and then on.
* Press the Maintenance switch to power off
the maintenance card, then press it again
to power on.
* Issue a command from Web browser of
EXPRESSSCOPE Engine 2 or NEC
ESMPRO Manager.
2. If the same error persists, contact your
service representative.