NEC EcoPowerGateway N8142-36F User Manual page 120

6-14 Troubleshooting
When STATUS lamp is blinking in amber:
On-screen
message
Proc Temp Alm 00
Proc Temp Alm 07
BB Temp2 Alm 00
BB Temp2 Alm 07
BB Temp1 Alm 00
BB Temp1 Alm 07
VBAT Alm 00
VBAT Alm 07
Description
A low temperature
warning was detected on
processor.
A high temperature
warning was detected on
processor.
A low temperature
warning was detected on
base board.
A high temperature
warning was detected on
base board.
A low temperature
warning was detected on
base board.
A high temperature
warning was detected on
base board.
A voltage warning (lower
limit) was detected on
lithium battery.
A voltage warning (upper
limit) was detected on
lithium battery.
Action
1. Check if dust or stain is adhered to the fan of
the power unit or not.
2. Check if blank cover is surely installed in the
slot which does not contain any power unit.
3. Check the ambient temperature of
installation location.
4. Take one of the following measures to reboot
(reset) the maintenance card.
* Press Ctrl + Alt + Del.
* Issue a command from Web browser of
EXPRESSSCOPE Engine 2 or NEC
ESMPRO Manager.
5. Take one of the following measures to power
off the maintenance card and then on.
* Press the Maintenance switch to power off
the maintenance card, then press it again
to power on.
* Issue a command from Web browser of
EXPRESSSCOPE Engine 2 or NEC
ESMPRO Manager.
6. Power off the maintenance card by pressing
the Maintenance switch.
Press the POWER switch of
EcoPowerGateway to turn off the power,
then turn it on. Then, press the Maintenance
switch to turn on the maintenance card.
7. If the same error persists, contact your
service representative.
1. Take one of the following measures to power
off the maintenance card and then on.
* Press the Maintenance switch to power off
the maintenance card, then press it again
to power on.
* Issue a command from Web browser of
EXPRESSSCOPE Engine 2 or NEC
ESMPRO Manager.
2. If the same error persists, contact your
service representative.