Table of Contents
Advertisement
Common
Option
Comment 1
Comment 2
Computer Name
Authentication Key
Community Name
Alert
Alert Process
Alert Acknowledge
Alert Level: *2
Remote Control (LAN1)
Redirection (LAN)
Parameter
Description
[
]
Enter the comment.
[
]
Enter the comment.
[
]
Specify the name of server to be
managed by NEC ESMPRO Manager.
Each server name must be unique.
[
]
Specify the authentication key for
connection between NEC ESMPRO
Manager and BMC. The
authentication key is required when
using the management LAN. The
authentication key you have set in
BMC is not displayed at the next boot
of SETUP BIOS. Be sure to remember
the key.
[public
]
Specify the community name for
SNMP trap sent from BMC. *1
Disabled
Specify whether the alert is sent or
[Enabled]
not. If Enabled, the alert is sent to the
destination where alert is enabled,
according to the setting for protocol
and alert level.
If Disabled, alert is not sent to any
destination.
[All]
Select "All" or "One".
One
All: An alert is sent to every media
where the alert is enabled.
One: An alert is sent to a single media.
If the alert is sent successfully, the
alert is not sent to the remaining
destination having the lower priority.
[Disabled]
Enables or disables acknowledgement
Enabled
of alert. If Enabled, the response from
the destination is acknowledged.
[Level0]
Specify the severity level of the event
Level1
to send an alert. This setting remain
Level2
unchanged even if [Clear BMC
Level3
Configuration] is executed (the initial
Level4
value is not restored.)
Level5
Level6
Disabled
Enables or disables remote
[Enabled]
management via LAN1. If Disabled,
NEC ESMPRO Manager cannot
connect with the EcoPowerGateway
via LAN1. An alert from the managed
server is not sent via LAN1.
Disabled
Enables or disables remote console
[Enabled]
feature via LAN. If Disabled, remote
console feature via LAN cannot be
used.
Configuring Your EcoPowerGateway 4-23
Your Setting
[
]: Factory-set
Advertisement
Table of Contents
Troubleshooting
