2. Updating The Software - Teldat ATLAS 150 Installation Manual

The LANx LED never lights up in
green.
The BRI LED never lights up in
either yellow or green.
The LEDS indicate the FE interfaces
are established but there is no
connectivity at the data layer.
II - 2. Updating the Software
The ATLAS 150
for further details on new releases.
There are various ways you can update a Teldat router: please see the manual on updating
software for further information.
The software required to update Teldat routers is supplied in a format known as
distribution. This consists of a single file which contains all the files needed to update
your device as well as in-depth information on the contents of the files.
router can be updated to new releases. Please consult your distributor
ATLAS 150
Check that the rear corresponding LINK LED is
ON; contrariwise check the Ethernet cable and
the connection to the network (you may need a
crossover cable).
If your device has an ISDN interface, check that
the connection to the bus is correct and that the
S bus terminal switch is in the correct position.
Check the configuration (routes, IP addresses,
etc).
Appendices
II-15
Doc. Dm697-I
Rev. 1.0