Sanremo OPERA The Revolution Instruction Booklet page 88

OPERA
4.6 - COMMISSIONING
4.6.a - First start-up (Fig. 8 - 9)
• Open the water supply tap upstream of the machine.
• Power on the machine power supply bringing the
breaker upstream of the machine to ON.
• Press the "ON/OFF" button (1) which turns on to
indicate that the machine is live; the unit displays
(2) turn on.
• The boiler is automatically filled with water; the grad-
ed scale "A" on the level display (3) turns on; when
the full level is reached, scale "A" is complete and
the display turns on fully.
• When the "MAX" level is reached, the graded scale
"A" stays o steady and the display is fully lit.
If automatic filling does not take place
within 120 seconds, the machine stops
and the LEDs on the unit button panels
light up and flash.
EN
2 Units
Installation and connection
IMPORTANT
A
124 MAX
°F
°C
085
°F
MIN
3
3
6
1
Check that the water supply tap is open.
• When filling is completed, dispense water from the
units by operating on levers (4), without fitting the
filter holders.
• Check that water comes out properly, venting any
air bubble present in the circuit.
Remove the cup heating plate (5) and
press button (6) for 3 or 4 seconds to fully
vent any air bubble in the circuit.
• Turn the steam dispensing levers (7) to open position
until steam is dispensed from the taps (8), then bring
the levers (7) back to the middle position.
• Dispense water by pressing button (9) located above
the unit to vent any air bubble in the circuit.
• Wait for the set temperature to be reached for steam
("123°C") and coffee water ("94°C"), which are shown
on display (3) and (2) of each dispensing unit, re-
spectively.
3 Units
A
MAX
124
°F °C
MIN
8
7
8 / 10
CAP. 4
IMPORTANT
Fig. 8
5
9
4
7
8
2
2
2
3
02-2014