Sanremo OPERA The Revolution Instruction Booklet page 103

CAP. 5
5.12.b - "Water dose" manual program-
ming(Fig. 19)
• Position a container under spout (1).
• Press button (2) on the first unit on the left for 10
seconds, until its LED flashes (3).
• Within 30 seconds, press button (4) to dispense hot
water, when the desired quantity is reached, press
button (4) again to stop dispensing.
The dispensed quantity is stored in memory.
5.12.c - Manual temperature programming.
Cup heating plate temperature (Fig. 20).
• Programming the temperature of the cup heating
plate is possible only using the first unit on the left.
• Press button (1) on the first unit on the left and keep
it pressed, at the same time move lever (2) forward
and use buttons (3) and (4) to set the heating of the
cup heating plate "ON" or "OFF"; the status of the cup
heating plate is shown in field "A" of the unit display.
• If the cup heating plate heating is "ON" in field "A",
the power is shown in field "B" as a % of the resist-
ance to heat the cup heating plate; use button (3) to
decrease power and button (4) to increase power.
• To confirm the data that were set, press button (1) to
move to programming the coffee water temperature.
02-2014
Operation of the machine
13 / 22
2
3
B
A
4
3
1
OPERA
Fig. 19
4
1
Fig. 20
EN
2