Reset to Factory Default
Reset to Factory Default window initializes all the parameters except Date and
Time to the factory default. If you forget the ID or password, you can operate the
Network Camera in the default settings. Please re-confirm before doing the Reset
to Factory Default operation.
1.
Click [Reset to Factory Default] on Setup Page.
2.
Click [Execute].
Resetting to Factory Default means initializing all the parameters of the
Network Camera including the ID, Password, IP address and Subnet Mask
except Date and Time.
•
Click [Cancel] to quit. It returns to the Setup Page.
Notes
•
Do not turn off the power during the Reset to Factory Default. It may
interrupt the Network Camera operation.
•
IP address and Subnet Mask should be set newly after Resetting to
Factory Default.
•
CLEAR SETTING button can reset the Network Camera to the Factory
Default. Please refer to 3.2 Network Camera reset procedure –
default settings.
•
If Reset to Factory Default is used, all user settings will be lost. You will
have to reconfigure the entire Network Camera.
86
Operating Instructions