Panasonic KX-HCM10 Operating Instructions Manual page 54

(1) Go to Top Page
(2) Network
(3) Name/Time
(4) Security:
Administrator
(5) Security: General
User
(6) Top View Image
(7) Image Transfer
(8) Camera Setup
(9) Multi-Camera
54
Item
Jumps to the Top Page. The Top Page accesses to
Single/Multi-Camera screen in Motion JPEG/JPEG
- Regularly Refresh. Refer to Page 56.
Configures the network setting (Static/DHCP ,
Default Gateway, Port No., DNS, DDNS,
Bandwidth). Refer to Page 57.
Enters the Camera Name on the Single Camera
screen. Date and Time setting is used in the Alarm/
Timer mode in the Image Transfer feature. Refer to
Page 59.
Sets administrator ID and password for the security.
The authentication window can be enabled.
Administrator should control the network system.
Refer to Page 60.
Sets General User ID and password for the security.
General User is the registered user. Refer to Page
62.
Sets the image resolution, image quality and
refreshing interval. Top View Image screen consists
of Single Camera and Multi-Camera screen. Refer
to Page 64.
Enables the Alarm/Timer mode in Image Transfer
feature. The Network Camera can transfer the
image via e-mail or FTP . The alarm/timer trigger can
be set on the Image Transfer window. Refer to Page
66.
Sets White Balance and Power Line Frequency. You
can lock the Pan/Tilt and/or Brightness Control
feature. Refer to Page 76.
The Multi-Camera screen needs to set up these
parameters. Enter the Network Camera names and
IP addresses of each Network Camera. The Multi-
Camera can display up to four images in a window.
Refer to Page 78.
Operating Instructions
Description