Update Firmware - Panasonic KX-HCM10 Operating Instructions Manual

Hide thumbs Also See for KX-HCM10:

Table of Contents

Operating Instructions

Update Firmware

Update Firmware window allows the user to install the latest version of the

Network Camera internal operating system. In most cases, this will never be

necessary. The present firmware has undergone extensive testing and was found

to be very reliable. Changes may be necessary to accommodate new operating

systems or new web browsers that are not shown on Page 9. In those cases,

Update Firmware would be available from Network Camera Technical Support

Site at http://www.kmelink.net/ipproducts/us/download/index.html. Please

check the current firmware version on the Setup Page on Page 53.

Notes

•

Do not turn off the power during Update Firmware. If the operation of

Update Firmware is stopped, please refer to Section

4.2 Troubleshooting.

•

Buffering Images are erased when performing Update Firmware.

Download the proper firmware from the Network Camera Technical Support

Site mentioned above.

If the Network Camera is accessible from the Internet, temporarily disable the

access and connect the Network Camera directly to the PC. This will eliminate

any interruption during the Update Firmware.

Note

When the Network Camera uses the DHCP function, please change the

Internet connection from DHCP to Static in Network window. Please refer

to Page 57 for the network parameters.

Enter "http://IP Address (or URL):Port No./config.html" on the web browser

and press [Enter] of the keyboard. When port no. is 80 (default), you do not

need to enter port no. Setup Page appears.

(Without Ethernet hub, you should use category 5 cross cable.)

(Category 5 straight cable)

Ethernet hub

Router

Table of Contents