Shipping The Printer; Prepare The Printer For Shipment - MINOLTA-QMS ENord magicolor 3100 User Manual

Shipping the Printer

If you need to ship your printer after it's been installed, follow these
procedures to prevent damage to the printer and to keep your warranty valid.
Attention
MINOLTA-QMS cannot be held responsible for damage to your printer
during shipment that results from the improper packaging of your
printer. You must use the instructions given in this section before
repacking the printer in its original shipping carton with the original
packing materials. These supplies must be replaced prior to shipping
the printer.
Do you have your original packaging?
If yes, you need only the Repacking Kit part number 1730872-901.
If no, you need both the Replacement Shipping Carton Kit part number
1730873-901 and the Repacking Kit part number 1730872-901. To order
either or both kits, in the United States, call MINOLTA-QMS Spares at
(251) 633-4300 x2530. For locations outside the United States, refer to
the Service & Support Guide or www.minolta-qms.com.
If you return the printer for service, be sure to write the RMA (Return
Merchandise Authorization) number you received from your customer
support representative on the outside of the carton before shipping the
printer.
If the RMA number is not clearly visible on the outside of the return
inventory, we will not accept receipt.
You can also have a MINOLTA-QMS authorized service provider
deinstall and repack your printer. For prices and availability, call
1 (877) 778-2657.

Prepare the Printer for Shipment

1
Turn off the printer.
Shipping the Printer
ENord- Istedgade 37A - 9000 Aalborg - telefon 96333500
149