MINOLTA-QMS ENord magicolor 3100 User Manual page 121

6
Insert the new DIMM
straight down into the
DIMM connector until
the latches snap into
the locked position.
Observe the keyed
side of the DIMM to
align it with the con-
nector. When seated,
the DIMM stands
upright, firmly in place.
If you cannot snap the
DIMM into place, do
not force it. Reposition
it, making sure that the
bottom of the DIMM is seated completely in the connector.
7
Reinstall the controller
board into the printer.
Gently slide the
controller board into
the printer's tracks
until it is fully seated,
and then tighten the
two screws.
8
Reconnect all
interface cables.
9
Reconnect the power
cord, and turn on the
printer (a startup page
should print, if
enabled).
5 "
In compliance with UL guidelines, "The appliance inlet is
considered to be the main disconnect device."
Dual In-Line Memory Modules (DIMMs)
ENord- Istedgade 37A - 9000 Aalborg - telefon 96333500
115