Installing Other Accessories - MINOLTA-QMS ENord magicolor 3100 User Manual

Introduction
Attention
It's very important to protect the printer controller board and any
associated daughterboard or module from electrostatic damage while
performing any task involving the controller board.
Attention
Use of accessories not manufactured/supported by MINOLTA-QMS is
not supported by your printer and will void your warranty.
This chapter provides information about the following accessories. Contact
your local vendor or www.minolta-qms.com for purchase information.
BuzzBox
Dual In-Line Memory
Modules (DIMMs)
(two available slots)
Emulations, Fonts,
Forms, and Other
Software
High-capacity Input
Feeder (HCIF)
Interfaces and
Daughterboards
Internal IDE Hard
Disk Drive
108
Via parallel connection for 100, 120, and 220 volts
Additional memory must be 32, 64, 128, or 256 MB
PC-100 Compliant SDRAM DIMMs, up to a
maximum of 512 MB.
„ ImageServer
„ LN03 Plus
„ VMS Host Software
„ CGM
„ Kanji Font Internal IDE Hard Disk Drive
„ QFORM
„ PlanetPress (forms-creation utility)
„ Fonts
With two 500-sheet media trays
„ Crown for DECnet-TCP/IP (equipped with
10BaseT)
„ CrownNet for Ethernet 10BaseT/100BaseTX
(equipped with RJ45 connector)
„ CrownNet for Token-Ring (equipped with STP
and UTP connectors)
„ SCSI Interface
Optional
ENord- Istedgade 37A - 9000 Aalborg - telefon 96333500
Introduction