MINOLTA-QMS ENord magicolor 3100 User Manual page 120

3
Remove the controller board from the printer.
Loosen two screws,
one on each end of
the I/O connector
panel, and, using the
tab on the lower side
of the connector
panel, pull the
controller board
from the printer.
4
Position the controller
board on a flat surface
so the controller
board lies flat and the
I/O connector panel is
facing you.
5 "
If you want to install more memory, you have to exchange one or
more DIMMs for DIMMs with a greater memory capacity.
5
If you need to remove a DIMM before installing one, remove it as follows;
otherwise, skip to step 6.
a
Using both thumbs,
pull the latches (one
on each side of the
DIMM connector)
outward.
b
Lift the DIMM straight
out of the DIMM con-
nector.
114 Dual In-Line Memory Modules (DIMMs)
ENord- Istedgade 37A - 9000 Aalborg - telefon 96333500