Clearing Media Jams - MINOLTA-QMS ENord magicolor 3100 User Manual

Message
MEDIA JAM
FEED
MEDIA JAM
FUSER
MEDIA JAM
REGISTRATION
MISMATCH JAM Near the

Clearing Media Jams

„
To avoid damage, always remove jammed media gently, without tearing it.
Any pieces of media left in the printer, whether large or small, can obstruct
the paper path and cause further jams.
„
To avoid damage to rollers, always remove jammed media gently.
„
Do not reload media that has jammed.
Attention
The image is not fixed on the media before the fusing process. If you
touch the printed surface, the toner may stick to your hands, so be
careful not to touch the print face when removing the jammed media.
Make sure not to spill any toner inside the printer.
Unfused toner can dirty your hands, clothes, or anything else it gets on.
If you accidentally get toner on your clothes, lightly dust them off as much as
possible. If some toner remains on your clothes, use cool, not hot water, to
rinse the toner off, provided your clothing is washable. If toner gets on your
skin, wash it off with water or a neutral detergent.
Clearing Media Jams
ENord- Istedgade 37A - 9000 Aalborg - telefon 96333500
Location of Jam
Multipurpose tray
Tray 1
(Optional) Tray 2
or Tray 3
Output tray
A misfeed jam may be as simple as a sheet of media not
being picked, or it may be that the media was picked but
not fed properly.
Near fuser unit
The registration
rollers below the
imaging unit
transparency
sensor
Access
Multipurpose tray
Upper media tray
HCIF media tray(s) page 73
Output tray
Button A
Button A
Button A
Page Reference
page 71
page 72
page 74
page 75
page 75
page 78
69