Wred-Profile - Dell MXL 10GbE Reference Manual

wred-profile

Create a WRED profile and name the profile.
Syntax
wred-profile wred-profile-name
To remove an existing WRED profile, use the no wred-profile command.
Parameters
wred-profile-
name
Defaults The five pre-defined WRED profiles. When you configure a new profile, the
minimum and maximum threshold defaults to predefined wred_ge_g values.
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage Use the default pre-defined profiles or configure your own profile. You cannot
Information delete the pre-defined profiles or their default values. This command enables
WRED configuration mode — (conf-wred).
dscp
Sets the number of specific DSCP values for a color map profile to yellow or red.
Syntax
dscp {yellow | red} [list-dscp-values]
To remove a color policy map profile, use the no dscp {yellow | red}
[dscp-list] command.
Parameters
Yellow
Quality of Service (QoS)
Enter your WRED profile name in character format (16
character maximum). Or use one of the pre-defined WRED
profile names. You can configure up to 26 WRED profiles
plus the five pre-defined profiles, for a total of 31 WRED
profiles.
Pre-defined Profiles: wred_drop, wred-ge_y, wred_ge_g,
wred_teng_y, wred_teng_g.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the yellow keyword. Traffic marked as yellow delivers
traffic to the egress queue which either transmits the packet
if it has available bandwidth or drops the packet due to no
ability to send.
1107