Port Low-Rate Otn Line Card - Cisco NCS 4016 Installation Manual

About Line Cards
Table 5-2
LED
Status
Attention
Port
1. The Attention LED can be lit only by using the hw-module attention-led location CLI command, which is useful for
Physical Characteristics
•
•
•
•

24-Port Low-Rate OTN Line Card

The 24-port low-rate OTN LC (NCS4K-24LR-O-S) supports up to:
•
•
•
OTU1 and OTU2 ports support generic forward error correction (GFEC). The card supports ODU2,
ODU1, ODU0, and ODUFlex switching functions by interconnecting with the centralized agnostic
switch fabric.
Figure 5-8
Cisco Network Convergence System 4000 Series Hardware Installation Guide
5-18
2-Port 100 Gbps and 10-Port 10 Gbps OTN and Packet Line Card Descriptions
State Description
Green The LC is properly seated and operating correctly.
Yellow The LC has one or more errors detected.
Off No power is applied to the LC.
1
Blue The card needs attention.
Off The card does not need attention.
Green The link is up (including internal loopback).
Yellow The link is down or a hardware failure has occurred.
Off The slice is unprovisioned by software, the optics
module is missing, or the slice has been powered
down.
identifying and verifying which card needs attention.
Height—11.05 in. (280.6 mm)
Width—1.55 in. (39.4 mm)
Depth—14.25 in. (362 mm)
Weight—6.57 lb (2.98 kg)
Twenty-four 1GE interfaces through SFP pluggable optics
Sixteen OC-48/STM-16/OTU1 interfaces through SFP pluggable optics
Four 10GE/OC-192/OTU2 interfaces through SFP+ pluggable optics
shows the details of the front panel of the 24-port low-rate OTN LC and LEDs.
Chapter 5 Installing Route Processor Cards, Fabric Cards, and Line Cards