Symbol PDT 7200 Series Product Reference Manual page 92

Note: The options available under the disks pull-down menu changes
depending on the flash type. Some flash types only have one option
for the number of disk volumes, others have two options.
6. If you have selected four volumes under the disk pull-down menu, you have the
option to change the memory configuration of the third and fourth volumes. To do
so, click on the up or down arrow for either of the volumes, until the memory
configuration of each is set to the desired value. You will notice that as you change
the values for one of the volumes, the other volume is automatically changed
accordingly.
7. Decide which volume will be the boot disk, and click on the boot disk box next to
that volume.This disk becomes the C: drive.
8. For each disk volume, determine the Read/Write access option.
9. The current path for your operating system source displays in the System File Path
field (MSDOS6.22 for DOS terminals). If this is not the correct path, click on the
Browse button and navigate to the correct directory.
10. The Script File Path displays the path of the selected script file.
11. Select a Cushion percentage from the Cushion pull-down menu to specify the
percent of flash reserved for cushion. Choosing a higher number reduces disk
storage space, but also increases write performance on fragmented disks or disks
becoming full. To speed the writing process, select as high a number as your
storage needs permit (up to 25%).
Terminal Configuration: Building and Sending the Hex Image
7-7