Using The Cradle; Charging The Terminal's Battery - Symbol PDT 7200 Series Product Reference Manual

Cradle Setup and Operation

Using the Cradle

Charging the Terminal's Battery

The Li-Ion battery is automatically recharged whenever the terminal is properly inserted in
the cradle. The terminal may be on or off.
To insert the terminal in the cradle, engage the terminal's scan bumper on the cradle rest,
then gently rotate the terminal into the cradle. Make sure the scan bumper is supported by
the cradle rest, as shown in Figure 3-3.
Terminal Charge LED
Scan Bumper
Cradle Rest
Spare Battery Charge LED
Communication LED
Figure 3-3. PDT 7200 Seated in Cradle
The terminal charge LED turns yellow when a terminal is placed in the cradle, and the
battery begins to charge. The terminal must be left in the cradle 2 hours to recharge a fully
discharged battery pack. Once charging is complete, the terminal charge LED turns green.
If the LED is off, either the terminal is not properly seated in the cradle, or a faulty battery
pack is installed in the terminal.
3-5