Symbol PDT 7200 Series Product Reference Manual page 67

PDT 7200 Series Product Reference Guide
Table 5-4. CardSoft Program/Data Storage (Continued)
Application Requirements
B Full CardSoft, Low, EMS (continued)
Socket Services
Card Services
ATA Support
SRAM Support
MTD Driver
Card ID
Power Management
Total
Uses 32 KB of extended memory, as 32 KB of
expanded EMS memory.
C Full CardSoft, High (Best Case), No EMS
Uses a total of 22 KB of conventional memory,
broken down as follows:
Card ID
Power Management
Total
Uses a total of 96 KB of extended memory as
one 64 KB UMB and one 32 KB UMB, of which
71 KB is used (see breakdown below). The
remaining 25 KB is available for use by other
software.
Socket Services
Card Services
ATA Support
SRAM Support
MTD Driver
Total
5-12
4 KB
43 KB
11 KB
3 KB
10 KB
1 KB
1 KB
73 KB
Load full CardSoft into UMBs (as much as
possible) without EMS.
Load HIMEM.SYS and EMM386.EXE in
CONFIG.SYS to provide UMB support.
21 KB
Use DOS=HIGH and DOS=UMB
1 KB
commands in CONFIG.SYS to enable
22 KB
loading DOS high and to enable UMB
support.
Use the following commands in
CONFIG.SYS:
DEVICEHIGH=ss365sl.exe
DEVICEHIGH=cs.exe
DEVICEHIGH=csalloc.exe
4 KB
DEVICEHIGH=atadrv.exe
43 KB
DEVICEHIGH=mtsram.exe
11 KB
DEVICEHIGH=mtddrv.exe
3 KB
DEVICE=cardid.exe
10 KB INSTALL=cs_apm.exe
71 KB Ensure that the files CSALLOC.INI and
CARDID.INI are placed in the directory in
which the CardSoft executables are
located.
Recommended Configuration(s)