Symbol PDT 7200 Series Product Reference Manual page 66

Application Requirements
A Full CardSoft, Low, No EMS
Application requires support of SRAM and ATA
cards, plus power management of cards.
Using additional conventional memory to hold
card configuration information is preferable to
using EMS memory.
Uses a total of 93 KB of conventional memory,
broken down as follows:
Socket Services
Card Services
ATA Support
SRAM Support
MTD Driver
Card ID
Power Management
Total
B Full CardSoft, Low, EMS
Application requires support of SRAM and ATA
cards and power management of cards.
Using EMS memory to hold card configuration
information is preferable to using additional
conventional memory.
Uses a total of 73 KB of conventional memory
(see breakdown of memory use that follows).
Table 5-4. CardSoft Program/Data Storag e
4 KB
43 KB
11 KB
3 KB
10 KB
21 KB
1 KB
93 KB
Terminal Configuration Issues
Recommended Configuration(s)
Load full CardSoft into conventional
memory without EMS.
Use the following list of commands in
CONFIG.SYS:
DEVICE=ss365sl.exe
DEVICE=cs.exe
DEVICE=csalloc.exe
DEVICE=atadrv.exe
DEVICE=mtsram.exe
DEVICE=mtddrv.exe
DEVICE=cardid.exe
INSTALL=cs_apm.exe
Ensure that the files CSALLOC.INI and
CARDID.INI are placed into the directory in
which the CardSoft executables are
located. Additionally, ensure that all Card
Library Files (.CLB) for card types that will
be used are loaded into the same directory
and referenced as CardLib= lines in the
[Libraries] section of CARDID.INI. Ensure
that the line UseEMS=No appears in the
[Common] section of CARDID.INI.
Same as option A above, but ensure that
the line UseEMS=Yes appears in the
[Common] section of CARDID.INI.
Load HIMEM.SYS and EMM386.EXE
(MIN=XXX RAM XXX) in CONFIG.SYS to
provide EMS support. Note that "xxx"
should be 32 KB plus the amount of EMS
needed for other software.
5-11