Symbol PDT 7200 Series Product Reference Manual page 68

Table 5-4. CardSoft Program/Data Storage (Continued)
Application Requirements
C Full CardSoft, High (Best Case) No EMS
(continued)
D Partial CardSoft, High, No EMS, Support for
ATA only.
Uses a total of 22 KB of conventional memory,
broken down as follows:
Card ID
Power Management
Total
Uses a total of 64KB of extended memory as
one 64 KB UMB, of which 58 KB is used (see
breakdown below). The remaining 6 KB is
available for use by other software.
Socket Services
Card Services
ATA Support
Total
E Partial CardSoft, High, No EMS, Support for
SRAM Only
Uses a total of 21 KB of conventional memory.
Card ID
Power Management
Total
Uses a total of 64 KB of extended memory as
one 64 KB UMB, of which 60 KB is used (see
breakdown below) and the remaining 4 KB is
available for use by other software.
Also ensure that all card library (.CLB) files
for card types that will be used are loaded
into the same directory and referenced as
CardLib= lines in the [Libraries] section of
CARDID.INI.
Ensure that the line UseEMS=No appears
in the [Common] section of CARDID.INI.
Load appropriate parts of CardSoft into
UMBs without EMS.
Same as option C, but use only the
following commands in CONFIG.SYS:
DEVICEHIGH=ss365sl.exee
21 KB
DEVICEHIGH=cs.exe
1 KB
DEVICEHIGH=csalloc.exe
22 KB
DEVICEHIGH=atadrv.exe
DEVICE=cardid.exe
INSTALL=cs_apm.exe
4 KB
43 KB
11 KB
58 KB
Load appropriate parts of CardSoft into
UMBs without EMS.
Same as option C, but use only the
following commands in CONFIG.SYS:
21 KB
DEVICEHIGH=ss365sl.exe
1 KB
DEVICEHIGH=cs.exe
22 KB
DEVICEHIGH=csalloc.exe
DEVICEHIGH=mtsram.exe
DEVICEHIGH=mtddrv.exe
DEVICE=cardid.exe
INSTALL=cs_apm.exe
Terminal Configuration Issues
Recommended Configuration(s)
5-13