Symbol PDT 7200 Series Product Reference Manual page 45

PDT 7200 Series Product Reference Guide
• the application requests a suspend via an API call, or the application sets a
wakeup.
• Critical
• the battery is removed or is very low.
• power switch required to resume.
The wake-up sources available on the PDT 7200 are listed in
Note: The default for enabling/disabling these wake-up causes depends
on how the terminal is suspended (manual suspend using the power
switch vs. automatic suspend via timeout). An application can also
override the defaults to control the cause of a terminal wakeup.
Touch panel power area
AC adapter connect
Cradle insert/remove
Battery insert
Scan trigger(s)
Keyboard (any key)
Touch pad (any touch)
Alarm timer
PCMCIA Slot
* Not supported at this time. Inserting a battery does NOT wake up the terminal.
† For these devices to cause a wakeup, they must be "rearmed" if they were enabled when
the terminal was suspended and the battery unlatched without an external power source
being connected. Wakeup sources do not function once the battery is re-installed until the
terminal is suspended and resumed again.
‡
Some cards are designed to wake up the terminal (e.g., radio or modem cards). Be sure to
use wakeup ONLY on cards that are designed for it and that you want to wake up.
4-4
Table 4-1. PDT 7200 Wakeup Sources
Source
Table
Manual Default
(power switch)
enabled
disabled
enabled
disabled
disabled
disabled
disabled
disabled
disabled
4-1.
Timeout Default
enabled
disabled
enabled
disabled*
disabled
†
disabled
disabled
disabled
† ‡
disabled