The Firmware Package Screen - ZyXEL Communications ZyWall USG 2000 User Manual

Chapter 52 File Manager
Table 254 Maintenance > File Manager > Configuration File (continued)
LABEL
File Name
Size
Last Modified
Upload
Configuration
File
File Path
Browse...
Upload

52.3 The Firmware Package Screen

Click Maintenance > File Manager > Firmware Package to open the
Firmware Package screen. Use the Firmware Package screen to check your
current firmware version and upload firmware to the ZyWALL.
868
DESCRIPTION
This column displays the label that identifies a configuration file.
You cannot delete the following configuration files or change their file
names.
The system-default.conf file contains the ZyWALL's default settings.
Select this file and click Apply to reset all of the ZyWALL settings to the
factory defaults. This configuration file is included when you upload a
firmware package.
The startup-config.conf file is the configuration file that the ZyWALL is
currently using. If you make and save changes during your management
session, the changes are applied to this configuration file. The ZyWALL
applies configuration changes made in the Web Configurator to the
configuration file when you click Apply or OK. It applies configuration
changes made via commands when you use the write command.
The lastgood.conf is the most recently used (valid) configuration file
that was saved when the device last restarted. If you upload and apply a
configuration file with an error, you can apply lastgood.conf to return to
a valid configuration.
This column displays the size (in KB) of a configuration file.
This column displays the date and time that the individual configuration
files were last changed or saved.
The bottom part of the screen allows you to upload a new or previously
saved configuration file from your computer to your ZyWALL
You cannot upload a configuration file named system-default.conf or
lastgood.conf.
If you upload startup-config.conf, it will replace the current
configuration and immediately apply the new settings.
Type in the location of the file you want to upload in this field or click
Browse ... to find it.
Click Browse... to find the .conf file you want to upload. The
configuration file must use a ".conf" filename extension. You will receive
an error message if you try to upload a fie of a different format.
Remember that you must decompress compressed (.zip) files before you
can upload them.
Click Upload to begin the upload process. This process may take up to
two minutes.
ZyWALL USG 2000 User's Guide