ZyXEL Communications ZyWall USG 2000 User Manual page 959

Table 288 Built-in Services Logs (continued)
LOG MESSAGE
SSH certificate:%s
format is wrong. SSH
service will not work.
TELNET port has been
changed to port %s.
TELNET port has been
changed to default
port.
FTP certificate:%s
does not exist.
FTP port has been
changed to port %s.
FTP port has been
changed to default
port.
SNMP port has been
changed to port %s.
SNMP port has been
changed to default
port.
Console baud has been
changed to %s.
Console baud has been
reset to %d.
DHCP Server on
Interface %s will not
work due to Device HA
status is Stand-By
DHCP Server on
Interface %s will be
reapplied due to
Device HA status is
Active
DHCP's DNS option:%s
has changed.
Set timezone to %s.
ZyWALL USG 2000 User's Guide
DESCRIPTION
After an administrator assigns a certificate for SSH, the
device needs to convert it to a key used for SSH.
%s is certificate name assigned by user
An administrator changed the port number for TELNET.
%s is port number assigned by user
An administrator changed the port number for TELNET back
to the default (23).
An administrator assigned a nonexistent certificate to FTP.
%s is certificate name assigned by user
An administrator changed the port number for FTP.
%s is port number assigned by user
An administrator changed the port number for FTP back to
the default (21).
An administrator changed the port number for SNMP.
%s is port number assigned by user
An administrator changed the port number for SNMP back to
the default (161).
An administrator changed the console port baud rate.
%s is baud rate assigned by user
An administrator changed the console port baud rate back to
the default (115200).
%d is default baud rate
If interface is stand-by mode for device HA, DHCP server can't
be run. Otherwise it has conflict with the interface in master
mode.
%s is interface name
When an interface has become the HA master, the DHCP
server needs to start operating.
%s is interface name
DHCP pool's DNS option support from WAN interface. If this
interface is unlink/disconnect or link/connect, this log will be
shown.
%s is interface name. The DNS option of DHCP pool has
retrieved from it
An administrator changed the time zone.
%s is time zone value
Appendix A Log Descriptions
959