Lexmark W850n Manual page 266

4024-110
5.
Remove the two screws securing the bracket (D) to the finisher.
6.
Remove the bracket (D).
7.
Remove the two screws securing the drive motor (exit) assembly to the bracket (D).
8.
Remove the drive motor (exit) assembly (C).
Replacement notes
Note: The tension of the belt (exit) (B) is automatically adjusted by the force of the spring attached to the belt
tensioner bracket (A).
Note: Tighten the two screws in the order shown.
4-114
Finisher Service Manual
D
C
Connector