Lexmark W850n Manual page 268

4024-110
6.
Disconnect the connector from the drive motor (buffer/transport).
7.
Remove the two screws securing the bracket (E) to the finisher.
8.
Remove the bracket.
9.
Remove the two screws securing the drive motor (buffer/transport) to the bracket.
10.
Remove the drive motor (buffer/transport).
11.
Remove the belt (buffer/transport) (D).
Replacement notes
Note: The tension of the belt (buffer/transport) (D) is automatically adjusted by the force of the spring attached
to the belt tensioner bracket (C).
Note: Tighten the two screws in the order shown.
4-116
Finisher Service Manual
Connector
E
B