Bridge unit idler rolls removal
1.
Open the bridge unit top cover assembly.
2.
Remove the bridge unit left shaft assembly. See
page
4-10.
3.
Move the two transport belts (A) away from the two bridge unit idler rolls (B).
4.
Lift the two bridge unit idler rolls upward to release them from the bridge unit assembly (C).
5.
Remove the bushings (D) from the bridge unit idler rolls.
Replacement note: When replacing the bridge unit idler rolls, make sure the bushings are installed as shown.
"Bridge unit left shaft assembly removal" on
A
B
D
Flat
D
4024-110
C
Repair information
4-11