Lexmark W850n Manual page 253

5.
Remove the two screws securing the bracket (D) to the finisher.
6.
Remove the bracket (D).
7.
Remove the two screws securing the bracket (D) to the drive motor (entrance/paddle) (C).
8.
Remove the drive motor (entrance/paddle) (C).
9.
Remove the belt (entrance/paddle) (B).
Replacement notes:
•
The tension of the belt (entrance/paddle) (B) is automatically adjusted by the force of the spring attached to
the belt tensioner bracket (A).
•
Tighten the two screws in the order shown.
D
C
Connector
Repair information
4024-110
4-101