Sensor (Compiler Media In) Removal - Lexmark W850n Manual

Sensor (compiler media in) removal

1.
Remove the finisher front door assembly. See
2.
Remove the rear upper cover. See
3.
Remove the rear lower cover. See
4.
Remove the upper media bin assembly. See
5.
Remove the upper media bin vertical cover. See
6.
Remove the stapler unit frame. See
7.
Remove the media eject clamp motor assembly.
page 4-66.
8.
Remove the media eject unit assembly. See
9.
Remove the media eject motor assembly.
10.
Remove the media compiler unit assembly. See
page 4-69.
11.
Disconnect the connector from the sensor (compiler media in) (A).
12.
Release the hooks securing the sensor (compiler media in) (A) to the compiler unit assembly (B).
13.
Move the compiler media present actuator (C) downward as shown.
14.
Remove the sensor (compiler media present) (A).
"Rear upper cover removal" on page
"Rear lower cover removal" on page
"Stapler unit frame removal" on page
See."Media eject motor assembly removal" on page 4-78
Connector
C
"Finisher front door assembly removal" on page
"Upper media bin assembly removal" on page
"Right eject cover removal" on page
See"Media eject clamp motor assembly removal" on
"Media eject unit assembly removal" on page
"Media compiler unit assembly removal" on
B
A
B
4024-110
4-27.
4-24.
4-23.
4-20.
4-21.
4-54.
4-59.
Repair information
4-73