The Traffic Statistics Screen - ZyXEL Communications UAG4100 User Manual

Table 21 Monitor > System Status > Interface Status (continued)
LABEL
Status
TxPkts
RxPkts
Tx B/s
Rx B/s

7.4 The Traffic Statistics Screen

Click Monitor > System Status > Traffic Statistics to display the Traffic Statistics screen. This
screen provides basic information about the following for example:
• Most-visited Web sites and the number of times each one was visited. This count may not be
accurate in some cases because the UAG counts HTTP GET packets. Please see
80 for more information.
• Most-used protocols or service ports and the amount of traffic on each one
• LAN IP with heaviest traffic and how much traffic has been sent to and from each one
You use the Traffic Statistics screen to tell the UAG when to start and when to stop collecting
information for these reports. You cannot schedule data collection; you have to start and stop it
manually in the Traffic Statistics screen.
Chapter 7 Monitor
DESCRIPTION
This field displays the current status of each interface. The possible values depend on what
type of interface it is.
For Ethernet interfaces:
• Inactive - The Ethernet interface is disabled.
• Down - The Ethernet interface does not have any physical ports associated with it or
the Ethernet interface is enabled but not connected.
• Up - The LAN Ethernet interface is enabled and connected.
• Speed / Duplex - The WAN Ethernet interface is enabled and connected. This field
displays the port speed and duplex setting (Full or Half).
For virtual interfaces, this field always displays Up or Down. If the virtual interface is
disabled, it displays Inactive.
For VLAN and bridge interfaces, this field always displays Up or Down. If the VLAN or
bridge interface is disabled, it displays Inactive.
For PPP interfaces:
• Inactive - The PPP interface is disabled.
• Connected - The PPP interface is connected.
• Disconnected - The PPP interface is not connected.
This field displays the number of packets transmitted from the UAG on the interface since it
was last connected.
This field displays the number of packets received by the UAG on the interface since it was
last connected.
This field displays the transmission speed, in bytes per second, on the interface in the one-
second interval before the screen updated.
This field displays the reception speed, in bytes per second, on the interface in the one-
second interval before the screen updated.
UAG4100 User's Guide
79
Table 22 on page