Web Configurator; Web Configurator Access - ZyXEL Communications UAG4100 User Manual
Unified access gateway
Hide thumbs
Also See for UAG4100:
- User manual (451 pages) ,
- Application note (67 pages) ,
- Support notes (60 pages)
Table of Contents
Advertisement
Command-Line Interface (CLI)
The CLI allows you to use text-based commands to configure the UAG. Access it using remote
management (for example, SSH or Telnet) or via the physical or Web Configurator console port.
See the Command Reference Guide for CLI details. The default settings for the console port are:
Table 1 Console Port Default Settings
SETTING
Speed
Data Bits
Parity
Stop Bit
Flow Control
1.4 Web Configurator
In order to use the Web Configurator, you must:
• Use one of the following web browser versions or later: Internet Explorer 6.0, Firefox 8.0,
Chrome 14.0, Safari 4.0
• Allow pop-up windows (blocked by default in Windows XP Service Pack 2)
• Enable JavaScripts, Java permissions, and cookies
The recommended screen resolution is 1024 x 768 pixels.
1.4.1 Web Configurator Access
Make sure your UAG hardware is properly connected. See the Quick Start Guide.
1
In your browser go to
2
Type the user name (default: "admin") and password (default: "1234").
3
Click Login. If you logged in using the default user name and password, the Update Admin Info
4
screen appears. Otherwise, the dashboard appears.
Chapter 1 Introduction
VALUE
115200 bps
8
None
1
Off
http://172.16.0.1
or http://172.17.0.1. The Login screen appears.
UAG4100 User's Guide
20
Advertisement
Table of Contents
Troubleshooting
