Hardware Installation And Connection; Wall Mounting - ZyXEL Communications UAG4100 User Manual

Hardware Installation and Connection

2.1 Wall Mounting

You may need screw anchors if mounting on a concrete or brick wall.
Table 9 Wall Mounting Information
Distance between holes
Self-tapping screws (Diameter: 3 mm)
Screw anchors (optional)
Select a position free of obstructions on a wall strong enough to hold the weight of the device.
1
Mark two holes on the wall at the appropriate distance apart for the screws.
2
Be careful to avoid damaging pipes or cables located inside the wall
when drilling holes for the screws.
If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the
3
full depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way
in - leave a small gap of about 0.5 cm.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the
screws all the way in - leave a gap of about 0.5 cm.
Make sure the screws are fastened well enough to hold the weight of the UAG with the connection
4
cables.
Align the holes on the back of the UAG with the screws on the wall. Hang the UAG on the screws.
5
C
H A PT ER
206 mm
Two
Two
UAG4100 User's Guide
32
2