Audio Output; Stereo Settings - Polycom RealPresence Group 550 Administrator's Manual

Administrator's Guide for the Polycom RealPresence Group Series
Setting
Type
Audio Input Level
Audio Meter (not labeled)
Type
Audio Input Level
Audio Meter (not labeled)
Type
Audio Input Level
Audio Meter (not labeled)

Audio Output

Setting
Master Audio Volume
Bass
Treble
Type
Output Mode
Line Output Level

Stereo Settings

To send or receive stereo audio, make sure your Polycom RealPresence Group system equipment is set up
as described in Connecting Devices to the Polycom RealPresence Group 300, RealPresence Group 500,
and RealPresence Group 550 Microphone Inputs
Then configure the system to use Polycom StereoSurround, test the system configuration, and place a test
call.
If you are in a call with a far site that is sending audio in stereo mode, you can receive in stereo. In multipoint
calls where some sites can send and receive stereo and some sites cannot, any site that is set up to send
or receive stereo will be able to do so.
Polycom, Inc.
Description
Displays HDMI 2 (HDMI connector embedded audio input, associated with video
input 2).
Sets the audio input level.
Displays the audio level of the line input, left and right channels.
Displays HDMI 3 (HDMI connector embedded audio input, associated with video
input 3).
Sets the audio input level.
Displays the audio level of the line input, left and right channels.
Displays Component (dual RCA, associated with component video input 4).
Sets the audio input level.
Displays the audio level of the line input, left and right channels.
Description
Sets the main audio output volume level going to the speakers.
Sets the volume level for the low frequencies without changing the master audio
volume.
Sets the volume level for the high frequencies without changing the master audio
volume.
Display the current audio output type.
Specifies whether volume for a device connected to the line out connectors is variable
or fixed.
• Variable — Allows users to set the volume with the remote control.
• Fixed — Sets the volume to the Audio Level specified in the system interface.
Displays the output level meter for the current audio output type.
on page 69 and Connecting Audio Output
Microphones and Speakers
on page 72.
77