Configuring The Ip Policy Route Entry - ZyXEL Communications ZyWall 70 User Manual

Internet security appliance

Hide thumbs Also See for ZyWall 70:

Table of Contents

Table 107 Policy Route Setup

Source Address/

Address/Port

19.5 Configuring the IP Policy Route Entry

Click the edit icon to open the screen as shown next.

Chapter 19 Policy Route

This is the source IP address range and/or port number range.

This is the destination IP address range and/or port number range.

Enter the IP address of the gateway. The gateway is a router or switch on the same

network segment as the device's LAN or WAN port. The gateway helps forward

packets to their destinations.

This is the IP protocol and can be ICMP, UDP, TCP or ALL.

This field specifies whether action should be taken on criteria Matched or Not

Click the edit icon to go to the screen where you can edit the routing policy on the

Click the delete icon to remove an existing routing policy from the ZyWALL. A

window display asking you to confirm that you want to delete the address mapping

Type a policy route's index number and the number for where you want to put that

rule. Click Move to move the rule to the number that you typed.

The ordering of your rules is important as they are applied in order of their

ZyWALL 70 User's Guide