4-3 Optimizing Printing to Match Media Thickness
Adjusting Head Height to Match Media Thickness
Procedure
MENU
HEAD HEIGHT
HEAD HEIGHT
MIDDLE
Move the lever.
W 2600 mm
SETUP SHEET
Description
Depending on the media, media may wrinkle or come loose from the platen during printing, increasing the
chance of contact with the print heads. When you are using such media, adjust the head height to "High."
Note that the height of the heads cannot be determined by just the thickness of the media.
When the height is set to "Low," the media clamps cannot be used. Except in special cases, the "Low" setting
should never be used. Doing so may cause the heads to strike the clamps and become damaged.
68
Chapter 4 Feature Reference
Downloaded From ManualsPrinter.com Manuals
Press
Press
Press
MIDDLE
Press
Press
Use
.
several times.
.
Height-adjustment lever
Move firmly, until it stops.
.
.
to go back to the original screen.
High
Middle (standard)
Low (normally not available
for use)