4-4 Optimizing Printing to Match Media Thickness
Adjusting Head Height to Match Media Thickness
Procedure
MENU
HEAD HEIGHT
HEAD HEIGHT
MIDDLE
Move the lever to adjust the height of the head.
HEAD HEIGHT
MIDDLE
Present setting
displayed
W 1839 mm
SETUP SHEET
Description
Depending on the media, media may wrinkle or come loose from the platen during printing, increasing the chance of
contact with the print heads. When you are using such media, adjust the head height to "HIGH."
Note that the height of the heads cannot be determined by just the thickness of the media.
When the height is set to "LOW," the media clamps cannot be used. Except in special cases, the "LOW" setting should
never be used. Doing so may cause the heads to strike the clamps and become damaged.
Default Setting
[HEAD HEIGHT]: MIDDLE
72
Chapter 4 Feature Reference
Press
Press
Press
MIDDLE
Press
HIGH
Present after
change displayed
Press
Press
.
several times.
.
High
Height-adjustment lever
Move firmly, until it stops.
Middle (Standard)
Low (normally not available for use)
to enable the setting.
.
to go back to the original screen.