Toyota 1996 LAND CRUISER User Manual page 1059

RS−36
SUPPLEMENTAL RESTRAINT SYSTEM
INSTALLATION
NOTICE:
Never use SRS parts from another vehicle. When replacing parts, replace with new parts.
S
Never reuse the airbag sensor assembly involved in a collision when the airbag has deployed.
S
Never repair a sensor in order to reuse it.
S
1. INSTALL AIRBAG SENSOR ASSEMBLY
(a) Using a torx wrench, install the airbag sensor assembly with the 4 screws.
Torx wrench: T40 (Part No. 09042−00020 or locally manufactured tool)
Torque: 21 N·m (210 kgf·cm, 15 ft·lbf)
(b) Connect the connector.
NOTICE:
Installation of the connector is done with the sensor assembly installed.
S
Make sure the sensor assembly is installed to the specified torque.
S
If the sensor assembly has been dropped, or there are cracks, dents or other defects in the
S
case, bracket or connector, replace the sensor assembly with a new one.
When installing the sensor assembly, take care that the SRS wiring does not interfere with other
S
parts and is not pinched between other parts.
After installation, shake the sensor assembly to check that there is no looseness.
S
2. INSTALL THE REMOVED PARTS
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
− AIRBAG SENSOR ASSEMBLY
Brought to you by BirfMark
Version 1.00 - 12/21/2010
RS0PF−01