Toyota 1996 LAND CRUISER User Manual page 1290

SR−38
1996 LAND CRUISER (RM451U)
Brought to you by BirfMark
STEERING
INSPECTION
Dial Indicator
NOTICE:
When using a vise, do not overtighten it.
1. INSPECT BALL CLEARANCE
Using a dial indicator, check the ball clearance. Move the worm
30 mm
(1.18 in.)
gear up and down.
Maximum clearance: 0.15 mm (0.0059 in.)
Z14503
2. INSPECT CROSS SHAFT ADJUSTING SCREW
THRUST CLEARANCE
Using a dial indicator, measure the thrust clearance.
Standard clearance: 0.03 − 0.05 (0.0012 − 0.0020 in.)
Dial Indicator
Z14504
3. IF NECESSARY, ADJUST CROSS SHAFT ADJUSTING
SCREW THRUST CLEARANCE
(a) Using a chisel and hammer, unstake the No.1 lock nut.
Z10600
(b) Using SST, remove the No.1 lock nut.
SST
(c) Using a screwdriver, adjust the adjusting screw for correct
thrust clearance.
(d) Using the SST, tighten a new lock nut.
(e) Using a chisel and hammer, stake the lock nut.
4. IF NECESSARY, REPLACE OIL SEAL, METAL
SPACER AND TEFLON RING
(a) Using a screwdriver, pry out the oil seal from the gear
housing.
(b) Using snap ring pliers, remove the snap ring from the gear
housing.
(c) Remove the metal spacer, teflon ring and O−ring from the
gear housing.
Z06211
Brought to you by BirfMark
Version 1.00 - 12/21/2010
− POWER STEERING GEAR
09630−00014 (09631−00051)
SR16O−01